So I did go through all the suggestions.
Using the Recovery Mode didn't change it.
I used it booting from spinning disks as well as booting from USB stick.
Either it boots fine or it hangs directly after "initial ramdisk...".
Success ratio did not change.
Looking at the wiki and man pages on initramfs I learned, that debug=vc writes the debug output to screen, so I did this. I also used break=something (with almost every possible value here).
Result is still the same. It either boots or it hangs (without any debug output) directly after "initial ramdisk...".
To me it looks like the machine isn't even able to start / mount the initramfs.
Does this make any sense?
And if it does, what could be a possible solution?
Using the Recovery Mode didn't change it.
I used it booting from spinning disks as well as booting from USB stick.
Either it boots fine or it hangs directly after "initial ramdisk...".
Success ratio did not change.
Looking at the wiki and man pages on initramfs I learned, that debug=vc writes the debug output to screen, so I did this. I also used break=something (with almost every possible value here).
Result is still the same. It either boots or it hangs (without any debug output) directly after "initial ramdisk...".
To me it looks like the machine isn't even able to start / mount the initramfs.
Does this make any sense?
And if it does, what could be a possible solution?
Statistics: Posted by quack — 2024-04-01 20:48 — Replies 4 — Views 186